Whirlpool Hall Effect Sensor

Pull the range forward and remove the top access cover.

Whirlpool hall effect sensor.

Cooling fan speed too low fan speed below 500 rpm either because the fan is spinning too slowly or because there is a problem with the hall effect sensor. Basically the hall sensor keeps an eye on the washer s motor to ensure it is working correctly and at the correct time during your washing cycle. As the element heats the sensor senses the ambient temperature inside the oven. If test results are not correct replace the hall sensor.

Manufacturer part w11107275. Manufactured by whirlpool oem. This is a new genuine whirlpool replacement part. The whirlpool oven sensor protrudes from the rear wall of the oven and connects to the oven thermostat.

5 check the hall sensor by removing the control board p7 connector and testing for 5 vdc between p7 7 and p7 1. Jose for model number kp26m1xmr. Check the hall sensor by removing the control board p7 connector and testing for 5 vdc between p7 7 and p7 1. Does the hall effect sensor included on the speed control assembly.

I checked the output to the hall effect sensor at the board which you need to have the oven plugged in and running to do this test contrary to the code sheet troubleshooting instructions and it was 5v dc. Plug in range or reconnect power. Start a cook cycle and check for proper operation. Range oven blower motor with hall sensor.

8 start a cook cycle and check for proper operation. 7 plug in range or reconnect power. If test results are not correct replace the hall sensor. 5 check the hall sensor by removing the control board p7 connector and testing for 5 vdc between p7 7 and p7 1.

So far so good. Finally figuring out a way to test the hall sensors without taking the motor apart. Part number pd00037690. It helps the control board make sure that everything is running as it should.

If test is good go to step 6. Replace all parts and panels before operating. 8 start a cook cycle and check for proper operation. If test is good go to step 6.

So for giggles i checked the output of the hall sensor to the board while running and it was barely 1 volt dc. Top rated repair story eric from nc. Unplug range or disconnect power. 3 people found this helpful.

7 plug in range or reconnect power. If test results are not correct replace the hall sensor. If test is good go to step 6. The hall sensor also known as the rotor position sensor rps is part of the automated system of your washing machine.

Verify there are no obstructions in the blower.