Whirlpool Duet Washer Pressure Sensor Hose

Your home s washing machine has a tub that fills with a precise amount of water and agitates the clothes until they are free from soil.

Whirlpool duet washer pressure sensor hose.

This video provides step by step repair instructions for replacing the pressure switch on a whirlpool front load washer. As you know almost all washing machines have two places to be used as a place for cold and hot water. My whirlpool duet washer displayed sud and f35 errors. Replacing this part is straight forward.

A whirlpool duet washer uses a water pressure switch to determine how much water to let into the tub. The switch also detects issues with oversudsing or overfilling. From the manufacturer. And do a duet washer quick diagnostic test the c06 portion of the quick test should fill the washer to wash level.

Most people believe this to be the fault of the analog pressure sensor aps and most people replace it. The most common reason for replacing. Whirlpool washers whirlpool washing machine parts. I did so and it worked but now three years later the problem repeated.

If your washing machine is functioning properly until your washing machine has been able to wash to the rinsing stage then suddenly dies then it is possible that your washing machine is stuck and this can cause your washing machine to get caught. Whirlpool w10004260 pressure switch hose. As the tub fills the switch cuts off the water flow when the water level inside the tub correlates with the setting for a large regular or small load. How to check a pressure switch on a washer.

Whirlpool duet washer stuck on sensing. Turns out this is a common problem. The model number and name for the following item is. Water level switch function.

The hose is located in the back of the washer on side with the drain hose. When the control display says sud or f1 you will need to test the pressure switch to ensure that it is working properly. Looks like a flow issue but if your water is filling and getting stuck when it goes to rinse with water visible in the washer this and the sensor are what you need. The pressure sensor is somewhat difficult to test directly so the easiest way is to visual check that the pressure hose connecting the switch to the tub is not pinched or kinked.

The water level switch sends power from the timer control to the water inlet valve and the temperature switch each time the tub needs to be filled during a wash cycle.